Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across University Park
University Park runs on tight lots and shared rooflines, and that changes how cap and crown work gets done here. A failed cap on a double stack doesn’t just let debris into your flue; it feeds the neighboring one too. We know these blocks, the pitched composition and slate roofs, and the pecan and oak canopy over the alleys that stuffs seed pods into every open flue each spring. If your cap is torn or your crown is cracking, call (833) 769-0219. We answer 24/7.
Why University Park Homeowners Call Chimney Sweep Preston Hollow for Chimney Cap & Crown
Homeowners in University Park call us because cap and crown problems here are rarely one-house problems, and that takes a specialist who reads the whole stack, not just the flue in front of them. When we look at a chimney on a narrow lot near Curtis Park or along Lovers Lane, we’re checking the neighbor’s venting opening too, because a half-capped double stack cross-contaminates both sides with debris and moisture. Our technicians have up to 9 years of experience with masonry chimneys on prewar and mid-century brick homes, and we carry professional-grade components from Gelco, Famco, and Olympia Chimney, matched to the actual clay tile dimensions rather than whatever fits loosely.
We work University Park regularly, so we’re familiar with the City’s permitting and historic-adjacent design oversight, the pitched roofs that make safe access a real part of the job, and the tight streets that slow a second-visit kind of repair. That means we survey and quote the full scope up front rather than discovering a shared-stack issue mid-job. The local pro we connect you with is licensed and insured as their state requires, and nothing gets recommended before you’ve seen the camera photos and the reasoning yourself.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in University Park
Your chimney is a system – cap, crown, liner, firebox – and on University Park’s closely spaced stacks, each piece affects the one beside it. Here’s how we handle the work.
Cap Installation
A new cap in University Park has to be sized to the actual tile openings, especially on the double and multi-flue stacks common in the 1920s-1950s Tudor and Colonial homes here. We install multi-flue caps from Olympia Chimney and Famco that cover every opening in the stack, not just the primary flue, so the neighbor’s venting opening doesn’t stay wide to the canopy. Proper flashing detail at the top matters as much as the cap itself.

Cap Replacement
Hardware-cloth and thin single-flue caps corrode and tear out fast under the pecan and oak seed-pod load dropping from the Park Cities alley canopy. When we replace a cap in University Park, we match the new unit to the liner dimensions and the existing flashing so the flue still drafts correctly and rain sheds away from the crown instead of behind it. On attached or adjacent stacks, replacement often means covering both openings at once.

Crown Repair
Original mortar crowns on University Park’s prewar brick chimneys crack and spall from the long hot-humid summers and short, wet winters, and that’s the path water takes down the flue liner, through the smoke chamber, into the firebox. Crown repair rebuilds the sloping wash so water sheds off the brick. We photograph the crown first so you can see the hairline cracks and spalling for yourself before any work is discussed.

Crown Coating
When a University Park crown is worn but still structurally sound, a proper crown coating seals the surface and restores the shed without a full rebuild. We use Gelco crown coating products formulated for masonry exposed to North Texas heat and humidity. Coating is the lighter option, and we’ll tell you plainly when a crown can safely wait or when rebuild is the honest call.
For the full range of what we cover, see our Chimney Cap & Crown services.
Trusted Brands We Service in University Park
We work with professional-grade brands on University Park cap and crown jobs: Gelco and Famco for crown and cap components, Olympia Chimney for multi-flue caps, and DuraFlex and HeatShield where a cap or crown repair reveals liner damage underneath. We don’t stock parts on a truck, so the exact component for your stack is specified to your chimney’s dimensions and brought to the job. That keeps the fit right on the odd-sized openings you find on Park Cities stacks. We also service existing caps and crown work regardless of brand. One call to (833) 769-0219 gets the whole scope covered.
See the difference
Before
After
Before
After
Before
AfterCommon Chimney Cap & Crown Problems We See in University Park Homes
- Corroded caps tearing out under seed-pod load. Cheap hardware-cloth and single-flue caps fail fast when the oak and pecan canopy drops pods and twigs onto every roofline each spring. That lets debris and nesting material straight into the flue, and on attached stacks it feeds the neighbor’s opening too.
- Cracked mortar crowns on prewar brick chimneys. Original crowns on 1920s-1950s University Park homes crack and spall from the hot-humid summers and short wet winters. Water then runs down the liner and through the smoke chamber to the firebox, and it’s usually caught at a Level 1 inspection rather than after a chimney fire.
- Shared-stack cross-contamination. On closely spaced and attached double chimneys, one homeowner’s cap replacement leaves the neighbor’s open flue venting into the same stack. Both then take on debris and moisture, which is why cap work here is often a two-stack job.
- Ill-fitted caps pulling poorly. A cap installed without matching the clay tile liner dimensions and flashing detail leaves gaps at the flue top that admit rain around the crown and cut the draft. On a pitched slate or composition roof, that misfit also stresses the flashing over time.
Pricing for Chimney Cap & Crown in University Park, TX
Cap and crown work in University Park is priced per job by a written estimate, but you should know the typical ranges going in. A standard single-flue cap installation runs roughly $220-$420. A multi-flue cap sized to a double or shared stack runs about $450-$850, depending on the number of openings and the flashing detail. Crown repair on a prewar brick chimney typically runs $550-$1,200, and crown coating around $350-$700. Custom caps for odd-sized Park Cities stacks sit at the top of these ranges because they’re built to the opening, not the shelf.
What moves the number is access on a pitched roof, how many flues are in the stack, and whether a crown needs rebuild versus coating. The estimate is free, and the written estimate sets the final price. Call (833) 769-0219 to book a survey.
We Also Serve Cities Near University Park
Shared stacks and dense canopy don’t stop at the city line, so we also cover homeowners in Preston Hollow, Bluffview, East Dallas, and Highland Park. The same attention to neighboring flues and tree debris applies across these nearby communities. If you’re just outside our University Park routes, call and we’ll confirm coverage. Learn more about University Park and the surrounding areas we serve.
Serving University Park, TX – Our Local Coverage Area
We serve University Park and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in University Park
Yes. A single multi-flue cap can cover both tile openings in a shared stack, and it’s usually the right move. We measure each opening, match the cap to the liner dimensions, and set proper flashing so the shared stack sheds water cleanly on both sides. That stops one failed cap from feeding debris into the neighbor’s flue. Call (833) 769-0219 for an exact quote; estimates are free.
It’s worth addressing but not always an emergency. A hairline crack along the wash that’s caught early can often wait briefly if you’re heading into a dry stretch, but a crown with open cracks or spalling lets water down the liner and through the smoke chamber, and that damage gets more expensive the longer it runs. We photograph the crown and tell you plainly whether it can safely wait or should be repaired now. Call (833) 769-0219 to have it looked at.
Yes, and decorative fireplaces here need it more than heavy-burn ones. In University Park, the dense canopy dumps seed pods and nesting material into open flues every spring, and with fireplaces dormant through the long humid summer, that debris and moisture damage outpacing creosote is the norm. A cap keeps it out, and a Level 1 inspection catches crown wear before it becomes structural. Call (833) 769-0219 to book one.
The fix starts with clearing the nest and debris, then repairing or replacing the cap so the mesh doesn’t tear out again. On a University Park double stack, we also look at the neighboring opening venting into the same stack, since the same squirrel often moves next door. Then we check the crown for the hairline cracks that moisture intrusion leaves behind. Call (833) 769-0219 for a free estimate.
A custom cap is built to your exact tile opening and flashing, so it fits a non-standard Park Cities stack without gaps. Off-the-shelf Famco and Olympia caps work well when the opening is standard, but an odd-sized or shared stack can leave slack at the flue top that pulls poorly and admits rain around the crown. We’ll tell you honestly which one your chimney actually needs. Call (833) 769-0219 and we’ll confirm.
Call (833) 769-0219 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Nothing gets recommended without camera evidence you can see for yourself.
Written by the team at Chimney Sweep Preston Hollow.