Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Trusted Chimney Repair for Preston Hollow Homeowners
Masonry doesn’t fail all at once. It goes slowly, starting with a hairline crack in the crown or a soft spot in a brick below the roofline, and by the time water is staining the firebox in the living room the damage has been working for seasons. Chimney repair in Preston Hollow is mostly about catching that decay early, before a $400 repointing job turns into a rebuild. Our technicians have up to 9 years of experience reading exactly that kind of damage, and we handle the whole chimney as a system: cap, crown, liner, firebox, flashing and brick. Call (833) 769-0219 and we’ll get a free estimate on the books. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
What Our Chimney Repair Service Includes
Chimney masonry in North Texas takes a specific kind of beating. Long hot summers pull moisture out of brick and mortar, then the fall rains push it back in, and that cycle loosens joints that looked fine a year earlier. We repair the whole assembly rather than patching the one spot you noticed, because the section that failed first is rarely the only one on its way.
Mortar Repointing
Repointing is grinding out failed mortar joints and packing new mortar in their place, and it’s the single most common repair we make on older Preston Hollow chimneys. You need it when joints have receded from the brick face, crumble when you scratch them, or show vertical cracks running the length of the joint. We match the mortar mix to the brick so the repair moves with the wall instead of cracking the faces around it.
Spalling Brick Repair
Spalling is the flaking and popping of a brick’s outer face, usually after water has soaked in and pushed back out. It matters because each spall leaves a thinner brick and a wider opening for the next round of moisture. We cut out the failed units and set replacements that match the existing bond and color as closely as the original brick allows.
Chimney Waterproofing
Waterproofing is a breathable sealer applied to the masonry so rain runs off while vapor inside the chimney can still escape. It’s the right call for a chimney that’s structurally sound but keeps showing damp patches or white mineral bloom on the exterior. We apply it after repairs are complete, never over failing mortar, because sealing a bad joint just traps the problem underneath.
Flashing Repair
Flashing is the metal where the chimney meets the roof, and it’s the leak source homeowners most often blame on the masonry. You need it repaired when you see rusted or pulled-back metal, cracked tar at the seam, or water staining on the ceiling near the chase. We reset and seal the flashing so the roof-to-chimney joint sheds water the way it was designed to.
Chimney Rebuilding
Rebuilding means taking the chimney down to a sound course and laying it back up, typically from the roofline to the top. It’s warranted when the brick above the roof has lost enough material that repointing won’t hold, or when the stack has leaned away from the house. We rebuild with new brick and a proper crown so the structure starts its next chapter correctly.
Tuckpointing
Tuckpointing is the finer version of repointing, where a finished mortar joint is styled to read as a crisp line against the brick. It’s used on visible chimneys where the masonry is part of the house’s look, not just its function. We do it on sound walls with cosmetic joint wear, and we’ll tell you plainly when standard repointing is the better value.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Brands We Service for Chimney Repair
We work with a curated roster of professional-grade materials, and each one earns its place on a specific kind of job. HeatShield is our choice for resurfacing a liner that’s cracked but still structurally intact, because it restores the flue from the inside without demolition. We also install chimney repair systems built around DuraFlex flexible liners, which handle the offset and bend in a flue that a rigid liner can’t follow. Both are the same materials specified by certified chimney professionals nationwide, and we use them because the repair has to outlast the cosmetic finish around it.
For the top of the chimney we install Gelco and Olympia Chimney components, mainly caps and crown materials, since the cap and crown are where most water intrusion starts. Knowing where each brand wears out matters as much as installing it: a Gelco crown mix ages differently from a poured concrete one, and a flexible liner needs its top plate checked at the same time as the flue. Whether you have Gelco, Olympia Chimney or any other make on your roof, we can help.
Signs You Need Chimney Repair Right Now
- Crumbling mortar joints. If mortar sands away under a fingernail or you can see the joints recessed behind the brick face, water is already inside the wall. Repointing early costs a fraction of rebuilding the same section later.
- White staining on the exterior brick. That chalky bloom is mineral salts pushed out by moisture moving through the masonry. It’s a reliable signal that water is getting in somewhere, often at the crown or flashing rather than the brick itself.
- Rust or water stains inside the firebox. Rust on the damper or a stain line on the firebox brick means water is coming down the flue. That points to a failed cap, crown or flashing, and it needs to be traced before it reaches the framing.
- Bricks flaking or falling on the roof. Spalled brick dropping onto shingles is a structural warning, not a cosmetic one. Have it looked at before a loose unit lands somewhere worse.
- A chimney that leans or has a visible crack running through it. Any movement in the stack, or a crack wide enough to hold a coin, calls for an inspection before the next heavy rain. Call (833) 769-0219 and we’ll get someone out to look at it.
Our Chimney Repair Process – Step by Step
Every job starts with an inspection, because guessing at masonry damage is how homeowners end up paying twice. Here’s how a repair runs from first call to final walkthrough.
- 1
Inspection and photo documentation. We examine the firebox, damper, flue, crown, cap and flashing, and we photograph what we find. You see the same images we do, so the recommendation isn’t something you have to take on faith.
- 2
A written scope with a flat price. We lay out what needs repairing now, what can safely wait a season, and what it costs. The estimate is free, and the written estimate sets the final price.
- 3
Protecting the house. Interior work gets drop cloths and a sealed work area; exterior work gets the roof and landscaping covered before any mortar comes down. Masonry work is dusty, and we plan for that.
- 4
The repair itself. Repointing, brick replacement, flashing reset or a liner resurfacing with HeatShield, done in the right order so a finish never goes over a defect. We don’t waterproof a wall until the joints behind it are sound.
- 5
Final check and walkthrough. We confirm water sheds where it should, the crown is intact and the flue is clear, then walk you through the finished work. One company handles every step, so there’s no handoff between a mason and a sweep.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Chimney Repair Cost in Preston Hollow?
Chimney repair in Preston Hollow typically runs from a few hundred dollars for spot masonry work up into the low thousands for a rebuild, and the range is wide because the jobs are genuinely different. A typical flashing repair or small tuckpointing job runs $300 – $800 depending on access and how much metal or mortar has to be replaced. Repointing a chimney above the roofline usually lands between $600 and $1,500, driven by height, square footage of joint and whether scaffolding is needed. Waterproofing a sound chimney typically runs $250 – $600. Spalling brick repair depends on how many units get cut out, commonly $500 – $1,200. A full chimney rebuild from the roofline up is the largest line item, generally $2,500 – $6,000 or more, depending on the height of the stack and the brick selected.
What moves the price most is access and extent, not the material itself: a chimney on a steep roof or behind landscaping takes longer to work on safely. The way to avoid overpaying is to get the failure properly diagnosed before anyone quotes a repair, which is why we inspect and document first. Our free estimate includes the inspection findings, a flat price for each item and a clear note on anything that can wait. Nothing gets recommended without evidence you can see for yourself, and if the honest answer is that your chimney can hold another year, we’ll say so.
Chimney Repair Near Preston Hollow – Our Service Area
We work across Preston Hollow and the surrounding neighborhoods, including Bluffview, University Park, Highland Park, Prestonwood, Lochwood, Forest Hills and Kessler Park, plus East Dallas, Lake Highlands, Farmers Branch and Addison. Scheduling is straightforward: call, tell us what you’re seeing, and we’ll book an inspection and estimate. For more on the repair side of our work, see our chimney repair page, and for homes closer to the northern neighborhoods we cover, chimney repair has the local details.
Serving Preston Hollow, TX – Our Local Coverage Area
We serve Preston Hollow and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Chimney Repair in Preston Hollow
Chimney repair is the masonry and metal work that restores a chimney’s structure and keeps water out, covering mortar joints, brick faces, the crown, flashing and the flue liner. It’s different from a sweep, which removes creosote, and from an inspection, which finds the problems in the first place. Most repair jobs we do in Preston Hollow start with one of those two visits and end with the masonry brought back to sound condition. Call (833) 769-0219 for an exact quote – estimates are free.
Most repairs take a single visit, with small tuckpointing and flashing jobs finishing in a few hours. Repointing a full chimney above the roofline usually runs one to two days, and a rebuild from the roofline up takes longer depending on the height of the stack and the weather. We give you a realistic timeline with the written estimate rather than a number pulled out on the spot.
Typical chimney repair in Preston Hollow runs from about $300 for small flashing or tuckpointing work to $6,000 or more for a full rebuild, with most repointing jobs landing between $600 and $1,500. The final price depends on access, how much masonry is affected and the materials chosen. The written estimate sets the price before work begins. Call (833) 769-0219 for an exact quote – estimates are free.
Yes, we install and service HeatShield liner resurfacing and DuraFlex flexible liner systems, along with Gelco and Olympia Chimney cap and crown components. HeatShield lets us restore a cracked flue from the inside without tearing out the surrounding masonry, and DuraFlex handles flues with an offset that a rigid liner can’t follow. If your chimney has a different brand installed, we can still inspect it and tell you what condition it’s in.
Same-day visits are often possible when you call early, and we’ll tell you honestly what the schedule allows. We answer 24/7, and fast dispatch runs from 7am to 7pm, Sunday through Friday, and we’re closed Saturday. A call outside dispatch hours gets booked into the next opening.
Our workmanship is backed by a satisfaction guarantee, and the specific coverage depends on the repair performed. A repointing job and a full rebuild carry different expectations, so we put the warranty terms in writing with the estimate. You’ll know exactly what’s covered before anyone starts work.
Clear the floor space in front of the fireplace and move anything fragile away from the hearth, since interior work involves drop cloths and some dust. If the repair is on the exterior, make sure we can reach the roof area and that gates or side yards are unlocked. Beyond that, you don’t need to do anything; we set up protection and clean up as part of the job.
Schedule Your Chimney Repair Service in Preston Hollow Today
Small masonry problems get more expensive the longer they sit, and the ones worth worrying about are usually the ones you can’t see from the ground. Call (833) 769-0219 to book a free, no-obligation estimate with photo documentation and a flat price before any work starts. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday. For our full range of services, start at Chimney Sweep Preston Hollow, and we’ll take it from there.
Written by the team at Chimney Sweep Preston Hollow.